AM Kustohms Coils – Alien (Nano) 329

Product Information Alien 327: 3×27/36ga, 6 wrap, 3mm ID @ 0.15Ohm (Recommended for RDAs) Alien 327-X: 3×27/36ga, 5 wrap, 3mm ID @ 0.12Ohm (Recommended for RDAs) Alien 329: 3×29/38ga, 7 wrap, 2.5mm ID @ 0.25Ohm (Great for decks with limited space like The Blotto) Alien 329-X: 3×29/38ga, 7 wrap, 3mm ID @ 0.27Ohm (Great for RTAs in general)   Fused 227: 2×27/38ga, 8 wrap, 3mm ID @ 0.28Ohm (Recommended for RTAs) Installation Guide To prevent any short-circuit on the coils, use tweezers with ceramic tips. Ensure your coils are installed close to the build deck – short coil legs. Pulse the coils at 30 – 40 watts (pulsing the coils for 0.5 – 1 second at a time until the coils are glowing). Use a ceramic tweezer to squeeze each coil. While pulsing the coils, check for any hot spots (brighter glowing parts). Lightly strum the the area with a ceramic tweezer until no hot spots are visible. After pulsing the coils and checking for hot spots, ensure all post screws are firmly tightened. Before wicking, leave the coils for about 30 seconds to cool down. Make sure to use enough cotton for the wicking. You should be able to move your vape by lightly tugging at the wick. Maintenance DO NOT use a wire/coil brush to clean the coils. After removing wick, drop wattage to 20 – 30 watts, pulse the coils until they’re glowing. Wait 20 seconds and dunk the coils in warm water. Repeat until any gunk has cleared out. Dry the coils with a paper towl. Remove the atomiser from vape and rinse under tap. Pulse coils again at 20 – 30 watts and check for hot spots, and leave to cool down for 30 seconds. Start to rewick.